TFT7HDW 7" Wireless Monitor Set, 4ch 4split 12/24V

Parking Camera - Operation in Use:

The monitor is connected to the ignition and the parking camera to the reverse light. When the ignition is turned on, the monitor is always in standby mode, turned off, but can be turned on and controlled with buttons. When reverse gear is engaged, the image from the camera appears immediately, and the monitor turns on automatically. However, the image is displayed in 4-split mode, meaning the parking camera image is only quarter-sized. But if the driver switches the image to the parking camera channel immediately after starting, then during driving, whenever reverse gear is engaged, the image will already be full-screen.

TIP: Ideally, the antennas should have as little blocked line of sight as possible. Use an extension cable with a stand during installation and route one antenna as close as possible to the other antenna; this will provide a smooth image from the camera even over longer distances (truck combinations, etc.).

Features

Common

• maximum range of 200 meters in open space
• video compression H264
• FHSS frequency hopping
• power cable with waterproof connector
• time delay 120ms
• shock resistance min. 4G
• frequency range 2400 - 2483.5 MHz
• power supply DC 12-24V
• operating temperature from -20 to +70 °C

Monitor

• 7" diagonal 16:9 image IPS panel
• display resolution 1024 x 600 RGB
• AV input 4x HD wireless video input
• function for simultaneous display of 4 cameras - 4SPLIT
• display options: 1 camera, 4 cameras
• image orientation setting (left, right, up, down)
• turn on/off guide lines Yes
• backlit buttons
• display backlight 500cd/m2
• TV system PAL/NTSC automatic
• no speaker
• no trigger wires
• dimensions 180 x 121 x 24 mm (without bracket and stand)

Camera

• image sensor CMOS 1/2.7”
• HD resolution 1280*720
• viewing angle: 140°
• water resistance IP69K
• no microphone
• dimensions 74 x 46 x 56 mm (without bracket and stand)
• material aluminum alloy

Package Contents: monitor, 1x camera, 2x antenna, 2x 1m power cable, 1x 3m extension cable with antenna stand, bracket, double-sided 3M tape, 2x hex key